Heat Treatment of Sintered Valve Seat Inserts Maurilio Pereira Gomes Igor Passos dos Santos Camila Pucci Couto Evandro Giuseppe Betini Luis Augusto Mendes dos Reis Cristiano Stefano Mucsi Marco Antônio Colosio Jesualdo Luiz Rossi 10.6084/m9.figshare.6943826.v1 https://scielo.figshare.com/articles/dataset/Heat_Treatment_of_Sintered_Valve_Seat_Inserts/6943826 <div><p>The characterization of sintered valve seat inserts (VSIs) after being subjected to different heat treatment operations has been carried out. The VSIs were obtained from three different alloys by mixing iron powder with AISI M3:2, AISI M2 high-speed steels, and AISI D2 tool steel. After sintering, the VSI were quenched in air followed by double tempering at seven different temperatures. The cooling rate during air quenching was measured by means of a thermocouple type k attached to a data acquisition system. The characterization of the mechanical and physical properties of the VSIs was achieved by measuring relative density, apparent hardness and crush radial strength. The resulting microstructures for the sintered parts were interpreted using the isothermal and continuous cooling transformation diagrams for similar alloys. The VSI obtained with AISI M3:2 and AISI M2 high-speed steels after air quenching and double tempering at 600 ºC showed the best results in terms of apparent hardness and crush radial strength.</p></div> 2018-08-08 02:46:06 Powder metallurgy High-speed steel Valve seat insert Heat treatment